2023 Latest DEA-5TT2 dumps – Instant Download PDF [Q18-Q36]

Q18. Which IEEE standard defines the Data Link Layer, Discovery protocol?

Q19. What accurately describes the comparison between stacking and VLT?

Q20. A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

Q21. Which IPv6 scope is used for private addressing on a local network?

Q22. Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?

Q23. What is the correct sequence of steps that occur in the communications between the client and server to obtain an IP address from a DHCP server?

Q24. A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?

Q25. In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

Q26. A network administrator has a stack of four Dell EMC Networking S4800 Series switches. Each stack unit is configured with a different priority. Which switch will be elected as the management device?

Q27. When configuring a switch, which CLI mode only supports limited show commands?

Q28. How is a switch different from a hub?

Q29. Router A is directly connected to Router B over an Ethernet link. The local interface address for the Router A Fo0/48 interface is 144.254.32.2/24. Which routing table entry is visible on Router A?

Q30. Which flags are used in the TCP header to initiate and end TCP connections or sessions?

Q31. Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?

Q32. Which topology is considered a best practice when stacking switches?

Q33. Which IP address is in the Class B range?

Q34. Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

Q35. If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

Q36. Which BASE-T Ethernet standard specifies a CAT6 cable type?