[Q24-Q42] The DEA-5TT2 PDF Dumps Greatest for the EMC Exam Study Guide!

QUESTION 24
Which IPv6 scope is used for private addressing on a local network?

QUESTION 25
In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

QUESTION 26
In IPv4, what is the proper conversion from binary to decimal for the number 11010010?

QUESTION 27
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

QUESTION 28
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?

QUESTION 29
What accurately describes the Simple Network Time Protocol (SNTP)?

QUESTION 30
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

QUESTION 31
On which OSI layers do standard ACL filters operate?

QUESTION 32
Which port type does a Dell EMC Networking N-Series switch have for its console connection?

QUESTION 33
A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

QUESTION 34
Which port type should be used for only VLAN-unaware devices?

QUESTION 35
Which flags are used in the TCP header to initiate and end TCP connections or sessions?

QUESTION 36
Which topology is considered a best practice when stacking switches?

QUESTION 37
Which port and protocol is used by NTP to communicate?

QUESTION 38
What is the aggregated lanes’ maximum speed rating for a QSFP28 transceiver?

QUESTION 39
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

QUESTION 40
A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces?

QUESTION 41
What accurately describes the comparison between stacking and VLT?

QUESTION 42
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?