View All 200-301 Actual Exam Questions Answers and Explanations for Free Mar-2025 [Q258-Q277]

07Mar 2025 by admin No Comments

4/5 - (3 votes)

View All 200-301 Actual Exam Questions Answers and Explanations for Free Mar-2025

The Most In-Demand Cisco 200-301 Pass Guaranteed Quiz

NEW QUESTION 258
Drag and drop the Cisco IOS attack mitigation features from the left onto the types of network attack they mitigate on the right.

Explanation:

NEW QUESTION 259
Which option describes the purpose of traffic policing?

It prioritizes routing protocol traffic.

It remarks traffic that is below the CIR

It drops traffic that exceeds the CIR.

It queues and then transmits traffic that exceeds the CIR.

NEW QUESTION 260
What are two benefits of controller-based networking compared to traditional networking?

controller-based increases network bandwidth usage, while traditional lightens the load on the network.

controller-based inflates software costs, while traditional decreases individual licensing costs

Controller-based reduces network configuration complexity, while traditional increases the potential for errors

Controller-based provides centralization of key IT functions. While traditional requires distributes management function

controller-based allows for fewer network failure, while traditional increases failure rates.

Cisco DNA Center Device Management
3. Monitor the cloud for software update
5. Uses CLI templates to apply a consistent configuration to multiple devices at an individual location
6. Uses NetFlow to analyse potential security threats throughout the network and take appropriate action on that traffic Traditional device management
2. Manages device configuration on a per-device basis
4. Security is managed near the perimeter of the network with firewalls, VPNs, and IPS Implements changes via an SSH terminal

NEW QUESTION 261
Refer to the exhibit.

Which action is expected from SW1 when the untagged frame is received on the GigabitEthernet0/1 interface?

The frame is processed in VLAN 5.

The frame is processed in VLAN 11

The frame is processed in VLAN 1

The frame is dropped

NEW QUESTION 262
Refer to the exhibit.

Which two commands, when configured on router R1, fulfill these requirements? (Choose two.) Packets towards the entire network 2001:db8:2::/64 must be forwarded through router R2.
Packets toward host 2001:db8:23::14 preferably must be forwarded through R3.

Ipv6 route 2001:db8:23::/128 fd00:12::2

Ipv6 route 2001:db8:23::14/128 fd00:13::3

Ipv6 route 2001:db8:23::14/64 fd00:12::2

Ipv6 route 2001:db8:23::/64 fd00:12::2

Ipv6 route 2001:db8:23::14/64 fd00:12::2 200

NEW QUESTION 263
Drag and drop the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.

Explanation:

NEW QUESTION 264
Drag and drop the statements about access-point modes from the left onto the corresponding modes on the right.

Explanation
A picture containing diagram Description automatically generated

NEW QUESTION 265
Which network allows devices to communicate without the need to access the Internet?

209.165.201.0/24

172.28.0.0/16

192.0.0.0/8

1729.0.0/16

The private ranges of each class of IPv4 are listed below:
Class A private IP address ranges from 10.0.0.0 to 10.255.255.255 Class B private IP address ranges from 172.16.0.0 to 172.31.255.255 Class C private IP address ranges from 192.168.0.0 to 192.168.255.255 Only the network 172.28.0.0/16 belongs to the private IP address (of class B).

NEW QUESTION 266
Refer to the exhibit.

Drag and drop the destination IPs from the left onto the paths to reach those destinations on the right.

Explanation:

NEW QUESTION 267
What is the purpose of using First Hop Redundancy Protocol in a specific subnet?

Filter traffic based on destination IP addressing

Sends the default route to the hosts on a network

ensures a loop-free physical topology

forwards multicast hello messages between routers

FHRP is layer 3 protocol whose purpose is to protect the default gateway by offering redundancy of the gateway in a subnet. This is achieved by allowing two or more routers to provide a backup for the first-hop IP router address. If a failure of an active router occurs, the backup router will take over the address. The routers negotiate their roles (Active/Standby) with each other by multicast hello messages to share the VIP (virtual IP address) between the FHRP routers. The terms Active/Standby vary between the different types of FHRP. The active router will act as the default gateway and the standby router acts as a backup the active router.

NEW QUESTION 268
Refer to the exhibit. Which minimum configuration items are needed to enable Secure Shell version 2 access to R15?

NEW QUESTION 269
Refer to the exhibit.

Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

passive

mode on

auto

active

NEW QUESTION 270
An engineering team asks an implementer to configure syslog for warning conditions and error conditions.
Which command does the implementer configure to achieve the desired result?

logging trap 5

logging trap 2

logging trap 4

logging trap 3

NEW QUESTION 271
Drag and drop the QoS congestion management terms from the left onto the description on the right.

NEW QUESTION 272
Refer to the exhibit.

Which route type does the routing protocol Code D represent in the output?

internal BGP route

/24 route of a locally configured IP

statically assigned route

route learned through EIGRP

NEW QUESTION 273
Refer to Exhibit.

Which action do the switches take on the trunk link?

The trunk does not form and the ports go into an err-disabled status.

The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.

The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.

The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

The trunk still forms with mismatched native VLANs and the traffic can actually flow between mismatched switches. But it is absolutely necessary that the native VLANs on both ends of a trunk link match; otherwise a native VLAN mismatch occurs, causing the two VLANs to effectively merge.
For example with the above configuration, SW1 would send untagged frames for VLAN 999. SW2 receives them but would think they are for VLAN 99 so we can say these two VLANs are merged.

NEW QUESTION 274
Refer to the exhibit.

A Cisco engineer creates a new WLAN called lantest. Which two actions must be performed so that only high-speed 2.4-Ghz clients connect? (Choose two.)

Enable the Broadcast SSID option

Enable the Status option.

Set the Radio Policy option to 802 11g Only.

Set the Radio Policy option to 802.11a Only.

Set the Interface/Interface Group(G) to an interface other than guest

NEW QUESTION 275
Which two functions are performed by the core layer in a three-tier architecture? (Choose two)

Provide uninterrupted forwarding service.

Police traffic that is sent to the edge of the network.

Provide direct connectivity for end user devices.

Ensure timely data transfer between layers.

Inspect packets for malicious activity.

NEW QUESTION 276
Which IPsec encryption mode is appropriate when the destination of a packet differs from the security termination point?

tunnel

transport

aggressive

main

Explanation
IPsec encryption mode is the way IPsec secures the data packets that are sent over an IP network. There are two main modes of IPsec encryption: tunnel mode and transport mode1. Tunnel mode encrypts the entire IP packet, including the original header, and adds a new IP header with the source and destination addresses of the security gateways (routers, firewalls, or VPN servers) that perform the encryption and decryption2. Transport mode encrypts only the payload (data) of the IP packet, leaving the original header intact, and uses the original source and destination addresses of the endpoints that generate and consume the data3. Therefore, transport mode is appropriate when the destination of a packet differs from the security termination point, as it does not change the original IP header information. Tunnel mode is more suitable when the security termination point is also the destination of the packet, as it provides more protection for the original IP header information.

NEW QUESTION 277
Refer to the exhibit.

An OSPF neighbor relationship must be configured using these guidelines:
* R1 is only permitted to establish a neighbor with R2
* R1 will never participate in DR elections
* R1 will use a router-id of 101.1.1.
Which configuration must be used?

Loading …

Understanding functional and technical aspects of 200-301 CCNA Exam: Cisco Certified Network Associate Network Security Fundamentals

The following will be discussed here:

Separation of control plane and data plane
Describe characteristics of REST-based APIs (CRUD, HTTP verbs, and data encoding)
Describe controller-based and software defined architectures (overlay, underlay, and fabric)
North-bound and south-bound APIs
Compare traditional campus device management with Cisco DNA Center enabled device management
Recognize the capabilities of configuration management mechanisms Puppet, Chef, and Ansible
Interpret JSON encoded data
Explain how automation impacts network management
Compare traditional networks with controller-based networking

200-301 Free Certification Exam Material with 990 Q&As : https://www.practicematerial.com/200-301-exam-materials.html

Understanding functional and technical aspects of 200-301 CCNA Exam: Cisco Certified Network Associate Network Security Fundamentals

Leave a Reply Cancel reply