[2023] Easy To Download H35-260 Actual Exam Dumps Resources [Q131-Q153]

QUESTION 131
IEEE 802.1Q defines the structure of VLAN tags, including TPID, PRI, CR, and VLAN ID. Which of the following is used to classify service priorities?

QUESTION 132
Which of the following ways does the Inspector inspection tool support adding network elements?

QUESTION 133
Which step is not included in the NE upgrade process of PTN equipment?

QUESTION 134
Since the CWDM system does not use optical amplifiers, the focus of commissioning is whether the optical reception of the OTU board is reasonable.

QUESTION 135
Which of the following statements about multiplexed partial range error indication (MS-REI) is true B2 byte represents the transmission channel.

QUESTION 136
OptiX OSN 6800 supports centralized crossover and distributed crossover. When two kinds of crossovers exist, the system prefers to use centralized crossover

QUESTION 137
The purpose of setting the upper and lower threshold alarms for performance monitoring through professional network management does not include which of the following?

QUESTION 138
PTN’s ACR time sodium and 1588 clock can achieve time synchronization.

QUESTION 139
In the WDM transmission system, the main factors that affect the unevenness of the power balance of each channel do not include the following?

QUESTION 140
When using the LCAS function, which of the following overhead bytes are used to transmit control information?

QUESTION 141
When the data is forwarded by the PTN device, when the value of the TYPE field of the Ethernet header is
8847, what protocol is the inner packet of the encapsulation?

QUESTION 142
Which of the following are the basic requirements of the DWDM system for the light source?

QUESTION 143
The device IP addresses of gateway network elements and non-gateway network elements must be set in the same network segment

QUESTION 144
Compared with PDH, which of the following are the main advantages of SDH?

QUESTION 145
In OptPTN3900, which of the following slots can MQ1 be placed in?

QUESTION 146
Which of the following descriptions about the IS-IS backbone area are correct?

QUESTION 147
In the chain networking of Huawei NG-SDH equipment, if the SCC board of a single station is faulty, the site and the downstream site cannot log in.

QUESTION 148
Which of the following descriptions about EDFA is wrong?

QUESTION 149
Which of the following optical loss alarms will not cause service interruption?

QUESTION 150
Which of the following detection methods can locate the fault point of LSP?

QUESTION 151
Standard Ethernet frame length should not be less than 64 bytes. Which of the following factors would cause this limitation?

QUESTION 152
Which of the following Ethernet port alarms is not a physical layer alarm, that is, LSR_NO_HTED has no correlation with it, and there is no suppression relationship?

QUESTION 153
Which of the following boards can be inserted into the OSN 9800U64 subrack?