[2023] New 2V0-41.20 exam dumps Use Updated VMware Exam [Q22-Q46]

QUESTION 22
Which three protocols could an NSX administrator use to transfer log messages to a remote log server? (Choose three.)

QUESTION 23
Which three functions require a Services Router (SR) component on an Edge node? (Choose three.)

QUESTION 24
Which two commands does an NSX administrator use to check the IP address of the VMkernel port for the GENEVE protocol on the ESXi transport node? (Choose two.)

QUESTION 25
Which network virtualization technologies can be used with an Ethernet VPN (EVPN) deployment in NSX-T Data Center? (Choose two.)

QUESTION 26
Which two ports are used by a transport node to communicate with the management and control planes in NSX-T Data Center 3.0? (Choose two.)

QUESTION 27
An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing.
Which failover detection protocol must be used to meet this requirement?

QUESTION 28
Which CLI command does an NSX administrator run on the NSX Manager to generate support bundle logs if the NSX UI is inaccessible?

QUESTION 29
Refer to the exhibit.

Which NAT type must the NSX-T Data Center administrator create on the Tier-0 or Tier-1 Gateway to allow Web VM to initiate communication with public networks?

QUESTION 30
Where are Distributed Firewall logs containing access decisions stored?

QUESTION 31
Which two statements describe the characteristics of an Edge Cluster in NSX-T 3.0 Data Center? (Choose two.)

QUESTION 32
Refer to the exhibit.

Which NAT type must the NSX-T Data Center administrator create on the Tier-0 or Tier-1 Gateway to allow Web VM to initiate communication with public networks?

QUESTION 33
When deploying east-west network introspection, which Service Virtual Machine (SVM) deployment method achieves the least amount of traffic hair pinning?

QUESTION 34
An NSX Administrator has created a segment named WEB-LS from the NSX UI and noticed the segment is not realized on the KVM Transport node.
What are two possible causes for this issue? (Choose two.)

QUESTION 35
Which statement is true about an alarm in a Suppressed state?

QUESTION 36
Which command is used to set the NSX Manager’s logging-level to debug mode for troubleshooting?

QUESTION 37
Which command is used to set the NSX Manager’s logging-level to debug mode for troubleshooting?

QUESTION 38
Which profile must be attached to the ESXi cluster to prepare the host for NSX-T Data Center?

QUESTION 39
Which tool could be used to configure BGP on a Tier-0 Gateway?

QUESTION 40
A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. A NSX-T Data Center administrator used the get logical-routers command to retrieve this information:

Which two commands must be executed to check BGP neighbor status? (Choose two.)

QUESTION 41
How does the Traceflow tool identify issues in a network?

QUESTION 42
Which tool could be used to inspect the path of a packet in the data plane?

QUESTION 43
Which CLI command on NSX Manager and NSX Edge is used to change NTP settings?

QUESTION 44
An NSX administrator has configured a load balancer virtual server on a Tier-1 Gateway.
In order to advertise the load balancer virtual IP to the Tier-0 Gateway, which route advertisement configuration has to be done on the Tier-1 Gateway? (Choose two.)

QUESTION 45
An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600.
Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?

QUESTION 46
Which log is used to see a failed NSX-T installation of a VIB package on ESXi transport nodes?