[Sep 04, 2026] 100% Pass Guarantee for NACE-CIP2-001 Dumps with Actual Exam Questions [Q37-Q59]

Q37. You are the NACE Level 2 Inspector with the final responsibility to prepare the final report for a very large structural steel shop project which has gone very well. It is due next week. The work has been ongoing for two years and several NACE Level 1 Inspectors have worked under your supervision throughout the project. You find you are missing one week of daily reports for the night shift from the very beginning of the project and despite your best efforts they are cannot found.
You FIRST preferred course of action is to:

Q38. As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

Q39. The HATE adhesion tester uses

Q40. Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?

Q41. When environmental enclosures are being used an inspector needs to be concerned about:

Q42. Thermal Spray coatings provide:

Q43. Measuring methyl ethyl ketone (MEK) resistance of ethyl silicate inorganic zinc-rich primers by solvent rub requires

Q44. Corrosion is the reverse process of

Q45. Dehumidification is defined as the removal of moisture vapor from the air to

Q46. The main reason dehumidification is used during coating operations is to

Q47. You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

Q48. WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

Q49. You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

Q50. The most likely area of failure on a buried external pipeline coating is the:

Q51. When completing the Final Inspection report the Inspector should write the report using:

Q52. When using a destructive Paint Inspection Gauge the NACE inspector must:

Q53. An Inspection and Test Plan is required when:

Q54. You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

Q55. Coating surveys may include which steps?
Select All That Apply:

Q56. You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

Q57. The primary purpose of Fireproofing coatings are to provide:

Q58. Inspection and Test plans are developed by referencing:

Q59. Antifouling coatings are regulated by international treaties.