[Jul-2023] HP HPE7-A01 Actual Questions and Braindumps [Q14-Q35]

Q14. You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?

Q15. For the Aruba CX 6400 switch, what does virtual output queueing (VOQ) implement that is different from most typical campus switches?

Q16. A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again.
Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Select two.)

Q17. A customer has a large number of food-producing machines
* All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120
* Several external technicians are maintaining this special equipment
What are the correct commands to ensure that no rogue DHCP server will impact the network?

Q18. Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

Q19. Refer to the image.

Your customer is complaining of weak Wi-Fi coverage in their office. They mention that the office on the other side of the hall has much better signal What is the likely cause of this issue7

Q20. You are helping an onsite network technician bring up an Aruba 9004 gateway with ZTP for a branch office The technician was to plug in any port for the ZTP process to start Thirty minutes after the gateway was plugged in new users started to complain they were no longer able to get to the internet. One user who reported the issue stated their IP address is 172.16 0.81 However, the branch office network is supposed to be on 10.231 81.0/24.
What should the technician do to alleviate the issue and get the ZTP process started correctly?

Q21. What are the requirements to ensure that WMM is working effectively’? (Select two)

Q22. What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?

Q23. What is enabled by LLDP-MED? (Select two.)

Q24. The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.
An administrator has performed the following configuration

What is the most likely cause of this issue?

Q25. You need lo have different routing-table requirements with Aruba CX 6300 VSF configuration Assuming the correct layer-2 VLAN already exists how would you create a new OSPF configuration for a separate routing table?

Q26. You are setting up a customer’s 15 headless loT devices that do not support 802.1X. What should you use?

Q27. A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX
8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem What is the solution for this?

Q28. Which statement best describes QoS?

Q29. Refer to the exhibit.

A company has deployed 200 AP-635 access points. To but is not working as expected What would be the correct action to fix the issue?

Q30. How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

Q31. A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network The access switches are AOS-CX switches.
What command should the administrator use to examine information on which role the guest user has been assigned?

Q32. Which statements regarding Aruba NAE agents are true? (Select two )

Q33. Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)

Q34. A customer wants to provide wired security as close to the source as possible The wired security must meet the following requirements:
-allow ping from the IT management VLAN to the user VLAN
-deny ping sourcing from the user VLAN to the IT management VLAN
The customer is using Aruba CX 6300s
What is the correct way to implement these requirements?

Q35. The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches What is the benefit of VSX clustering with the new solution?