Free NACE-CIP1-001 braindumps download (NACE-CIP1-001 exam dumps Free Updated Jan 09, 2024) [Q49-Q72]

NEW QUESTION 49
When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

NEW QUESTION 50
Removal of surface contaminants is done by:

NEW QUESTION 51
Relative humidity is

NEW QUESTION 52
A magnetic pull-off type gauge is a good choice when:

NEW QUESTION 53
Inspection documentation is important because:

NEW QUESTION 54
When applying Thermal Spray Coatings the specification is most likely to refence:

NEW QUESTION 55
SSPC SP 1 identifies the use of:

NEW QUESTION 56
You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

NEW QUESTION 57
ISO SA 2.5 is defined as:

NEW QUESTION 58
Fine cracks in the surface of a coating that rarely reach the substrate are called

NEW QUESTION 59
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

NEW QUESTION 60
The most important factor resulting in improved job site safety is:

NEW QUESTION 61
Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

NEW QUESTION 62
A NACE Coating Inspector is permitted to transport coating material when:

NEW QUESTION 63
Check abrasive blast pressure close to the

NEW QUESTION 64
Galvanic corrosion occurs on which of the following substrates:

NEW QUESTION 65
Prior to using Inspection Tools the inspector must:

NEW QUESTION 66
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

NEW QUESTION 67
In a non-convertible coating the role of the primary solvent is to:

NEW QUESTION 68
An inspectors personal log book should contain:

NEW QUESTION 69
You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners’ representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

NEW QUESTION 70
The form of corrosion that has the largest potential for unexpected catastrophic failure is:

NEW QUESTION 71
Silicone coatings are typically:

NEW QUESTION 72
When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to: